Name: QD6A - type II determinant bottle blowing machine

Explains: this machine for the QD6A ranks machine improved models, improve the instructions are as follows:

Cutting pliers clamp mechanism: the new cutting pliers clamp mechanism, by spline guarantee level two cylinder.

Vertical cooling mechanism: replace the old mold base, accelerate the bottle and molding cooling, increase productivity.

Quick change pressure blowing mechanism: replace the original pressure blow, replacement time shorten, made in production, rapid and convenient to replace.

Cantilever assembly: gear drive to replace the original chain transmission, makes the stable transmission, small gap.

Looked up and cylinder hydraulic buffer, the buffer effect is good.Does not need external drainage pipe, easy installation and maintenance.

The adjusting device: to install into the ranks of the front of the machine, easy to make.

Quantitative lubrication, lubrication pump station, the agency has the timing institutions can point injection oiling effect at the same time.

The main technical parameters:

Product weight range limit small mouth bottles of 30-1200 - g big bottles of 30-1000 - g

Limit size bottle diameter blow - 50 mm pressure - blowing method 90 mm

Blow, blow the bottle diameter 150 mm - 150 - mm pressure method

Height of the bottle blow - 240 mm - 315 - mm pressure method

Productivity in the biggest range of 15-90 / min

Minimum range 24-72 / min

Compressed air pressure low pressure 0.196 MPa (KGF/cm2) (2)

High pressure (3) 0.294 MPa (KGF/cm2)

Cooling air pressure of 3.73 KPa (380) (mmH2O)

Cooling air consumption of 2300 m3 / h

Fusion line 4000-42000 - mm above the floor