Servo Feeder :This type of feeder is a new feeder independently developed by our company. The punching and cutting system of the whole machine is controlled by imported servo motor. For the punching system, the servo motor drives the screw to realize the up and down movement of the punch. And the motion curve can be set instead of being limited by the cam curve trajectory in the old-fashioned feeder, which can easily adjust the drop to get the ideal type and is conducive to molding. For the cutting system, the servo motor drives the reducer to realize scissor’s opening and closing. It can also control the scissor’s moving speed to adapt to different shear speed. The mechanism can also be installed at the bottom of the wok to avoid the influence on the press operation and installation caused by the low altitude drip. The refining system is driven by bevel gear to realize the rotary of the cylinder with the inverter controlling its speed. The refining lift system uses the ball screw. It can be lifted relatively easily, which is more conducive to the operation. The feeder, with advantages of advanced structure, easy operation and smooth running, is the ideal choice for supporting utensils equipment.
1 |
Model |
SF |
2 |
The maximum daily output |
50 tons |
3 |
The range of drop weight |
30-3000 g |
4 |
Drop frequency per minute |
2-50 shear / min |
5 |
Height adjustment range of punch |
-20 - +200 mm |
6 |
Turning speed of refining cylinder |
0-10 rpm/min (frequency control,forward and reverse) |
7 |
Lift of refining cylinder |
0-75 mm |
8 |
Inner diameter of refining cylinder |
152 mm, 178 mm, 203 mm, 230mm (specified in order) |
9 |
Inlet width of the feeder spout |
410 mm 460 mm, 560 mm (specified in order) |